GENERAL PROGRAMS
OUTPUT TRAYS
(When the printer or fax function is enabled and a JOB SEPARATOR TRAY KIT or FINISHER is installed)
This program is used to select the respective output trays for the copy, printer, and fax functions.
The factory default setting is "PATTERN 1". Example: When a FINISHER is installed
*Settings that can be selected vary depending on the options that are installed.
Settings | Description |
PATTERN 1 | Copy: Offset tray |
| Printer: Center tray |
| Fax: Top tray |
|
|
PATTERN 2 | Copy: Center tray |
| Printer: Offset tray |
| Fax: Top tray |
|
|
PATTERN 3 | Copy: Center tray |
(When the fax | Printer: Offset tray |
function is enabled) | Fax: Center tray |
|
|
PATTERN 4 | Copy: Offset tray |
(When the fax | Printer: Center tray |
function is enabled) | Fax: Center tray |
|
|
OFFSET FUNCTION SETTING
This program is used to enable or disable the offset functions of the center tray and offset tray (when a FINISHER is installed).
This program is initially enabled (factory default setting).
MEMORY FOR PRINTER
This program is used to set the amount of IMC memory that is allocated to the printer function. The amount of memory can be set from 30% to 70% in increments of 10%.
The factory default settings are as follows:
•50 (%)
•THE MEMORY AREA FOR PRINT HOLD: 30 (%)
●Memory allocated to print hold
(When the PRINTER EXPANSION KIT is installed) To set the amount of memory allocated to print hold, touch the [THE MEMORY AREA FOR PRINT HOLD] key. The amount of memory can be set from 30% to 70% in increments of 10%. If 0% is selected, the print hold function cannot be used.
DISABLING OF CENTER TRAY COUNTING
This program is used to disable counting of pages delivered to the center tray.
When this program is enabled, center tray full detection does not take place.
This program is initially disabled (factory default setting).
RETURN FROM COPY MODE TIMING
(When the printer function or fax function is enabled)
This program is used to set the amount of time that must elapse after a copy job is finished before the printer or fax function resumes operation. The amount of time can be set from 1 second to 60 seconds in increments of 1 second.
The factory default setting is "60" (sec.).
MIX SIZE ORIGINAL FEEDING MODE
When this program is enabled, originals of mixed length (the widths must be the same) can be scanned in copy mode and each original copied onto the corresponding length of paper.
This program is initially disabled (factory default setting).
SECURITY SETTINGS
The following settings are related to security. Touch the [SECURITY SETTINGS] key to configure the settings.
●SSL SETTINGS
SSL can be used for data transmission over a network.
SSL is a protocol that enables the encryption of information communicated over a network. Encrypting data makes it possible to transmit and receive sensitive information safely.
•HTTPS: Apply SSL encryption to HTTP communication.
•
13