CONVENIENT COPY FUNCTIONS

1 Place the originals in the RSPF or on the document glass. (p.22, p.23)

If originals are placed in the RSPF, the sort function is automatically selected. (To disable this function, see the "Key operator’s guide".)

Example: 5 sets of copies or 5 copies per page of 3 originals

Originals

2 Touch the [OUTPUT] key.

2-SIDED COPY

OUTPUT

3 Touch the [SORT] or [GROUP] key.

OUTPUT

UPPER

TRAY

 

SORT

CENTER

TRAY

GROUP

4 Touch the output tray that you wish to use.

The output tray can only

UPPER

TRAYbe selected when a job separator or finisher is installed.

CENTER

TRAY

To enable the offset function (p.35), touch the Note [OFFSET] checkbox so that a checkmark

appears. To disable the offset function, touch the [OFFSET] checkbox again to clear the checkmark.

5 Touch the [OK] key.

OK

OFFSET

6 Select the number of copies and any other desired copy settings, and then press the [START] key ().

ACC.#-C

7 [When using the RSPF:]

Copying will start after all the originals are scanned.

[When using the document glass:]

Replace the original with the next original and press the [START] key (). Repeat this step until all originals have been scanned, and then touch the [READ-END] key.

PLACE NEXT ORIGINAL. PRESS [START].

WHEN FINISHED, PRESS [READ-END].

READ-END

The copies are grouped as follows:

SortGroup

CopyCopy

5 sets of copies

5 copies per page

If the memory becomes full while scanning the originals, "MEMORY IS FULL. PRESS [START] TO BEGIN COPYING OR [CA] TO CANCEL." will appear. To copy only the originals that have been scanned, press the [START] key () . To cancel the job, press the [CLEAR ALL] key ( ).

The number of originals that can be scanned Note into memory can be increased by increasing

the memory allocation in the key operator programs, or by installing more memory. (See the "Key operator’s guide".)

36