Sharp AR-M257 COPYING FROM THE RSPF

COPY FUNCTIONS

COPYING FROM THE RSPF

Note	•	If "AUDITING MODE" (p.58) is enabled, enter your 5-digit account number.
	•	If the RSPF is disabled in the key operator programs, the RSPF cannot be used. See the "Key operator's
		guide".

1 Make sure that an original has not been left on the document glass and then close the RSPF.

If an original remains on the document glass after a copy was made,

"REMOVE THE ORIGINAL FROM THE DOCUMENT GLASS." will appear in the touch panel.

2 Adjust the original guides to the size of the original.

3 Place the originals face up in the document feeder tray.

Insert the originals all the way into the feed slot. The original size appears in the touch panel.

•	Up to 100 pages (24 lbs. (90 g/m2)) can
Note	be inserted at once.

•If the original size is not automatically detected, manually set the original size. (p.47)

4 Make sure that the same size of paper as the original is selected.

			The selected tray is
ORIGINAL	8½x11	AUTO	highlighted. If none of the
			trays have the same size
		EXPOSURE
	8½x11	AUTO 8½x	of paper as the original,
		PAPER SELE	"LOAD xxxx PAPER."
8½x11
8½x14		100%	will appear.
		COPY RATI

Even if the message above is displayed, copying can be performed using the selected paper tray.

•	To load paper, see "LOADING PAPER"
Note	(p.15). If you change the paper size in the
	tray, you will also need to change the
	tray's paper size and paper type settings.
	(p.19)
•	If needed, manually select the paper tray
	that has the desired size of paper as
	explained on page 22.
• The paper types for the auto paper selection
	function can be selected, or the function
		2
	disabled, in the key operator programs. (See
	the "Key operator's guide".)
•	If the original size is larger than the paper
	size, the result of copying from the
	document glass may differ from the result
	of copying from the RSPF. (p.22)

5 Select the number of copies and any other desired copy settings, and then press the [START] key ().

ACC.#-C

•The number in the copy quantity display will decrease by 1 each time a copy is made.

•If you are only making a single copy, the copy can be made with the copy number display showing "0".

•To clear a mistake, press the [CLEAR] key ().

•	Press the [CLEAR] key (	) to stop
Note	copying in the middle of a run.

•If copying stops because the tray has run out of paper, you can resume copying by touching the [PAPER SELECT] key and selecting the bypass tray or a paper tray that has the same size and type of paper loaded in the same orientation.

Stream feeding mode

If stream feeding mode is enabled in the key operator programs, "SET ORIGINALS FOR STREAM FEEDING." will appear in the touch panel for approximately 5 seconds after the originals are fed. Any new originals placed in the RSPF while this message appears will be fed and copied automatically.

Copying a large number of originals

Job Build mode is useful when you need to copy more originals that can be placed in the RSPF at once. For information on Job Build mode, see "JOB BUILD MODE" (p.45).

23