TROUBLESHOOTING AND MAINTENANCE

MISFEED IN THE RSPF

1 Remove the misfed original.

Section C

Carefully remove the misfed original from the

Check sections A, B, and

C in the illustration at left

Aand remove the misfed

original.

B

C

exit area.

Section A

Document feeder cover

Open the document feeder cover and carefully remove the misfed original from the document feeder tray. Close the document feeder cover.

If the misfed original cannot be easily removed from the exit area, open the moveable part of the document feeder tray and remove the reversing tray, and then remove the original.

Reversing tray

Moveable

 

part

Section B

Roller

Open the RSPF and rotate the release roller in the direction of the arrow to feed the original out. Close the RSPF and then carefully remove the original.

If the misfed original cannot be removed, open the document transport cover (below), and rotate the release roller again.

Note

After removing a misfed original from the

5

exit area, be sure to attach the reversing tray

securely to the exit area (When the RSPF is installed.).

2 Open and close the RSPF to clear the misfeed message from the touch panel.

If a small original (5-1/2" x 8-1/2", etc.) is misfed, or if an original misfeed occurs in the reversing tray of the RSPF, lift the document transport cover knob, open the document transport cover, and remove the original.

Document transport cover

Document transport cover knob

The message can also be cleared by opening and closing the document feeder cover or the document transport cover.

After the misfeed is removed and the misfeed message is cleared, a message will appear indicating the number of originals that must be reinserted in the RSPF.

3 Reinsert the originals that still must be scanned (Including the original that was being scanned when the misfeed occurred.), and press the [START] key().

Copying of the remaining originals will resume.

67