DISPLAY MESSAGES

If one of the following messages appears in the display, take prompt action as instructed by the message.

Message

Cause and solution

Page

ENTER YOUR ACCOUNT

Auditing mode is enabled. Enter your account number.

58

NUMBER.

 

 

 

 

 

 

A MISFEED HAS OCCURRED.

Remove the misfeed as explained in "MISFEED REMOVAL".

66

 

 

 

2-SIDED COPIES CANNOT BE

This appears when you attempt to make two-sided copies on special

 

MADE ON THIS PAPER TYPE.

paper that cannot be used for two-sided copying. Cancel two-sided

15, 27

 

copying or change the paper.

 

 

 

 

REMOVE PAPER FROM THE

The indicated output tray is full. Remove the output from the tray.

-

<*>TRAY.

(<*> indicates the tray that is full.)

 

 

 

 

CLOSE THE <**> COVER.

The indicated cover is open. Close the cover. (<**> indicates the

-

 

cover that is open.)

 

 

 

 

 

PLEASE EXTEND BYPASS-TRAY.

When copying from the bypass tray, be sure to pull out the bypass

18

 

tray extension.

 

 

 

 

 

COVER SHEETS MUST BE THE

When adding a cover, load paper in the bypass tray that is the

 

SAME SIZE AS THE COPY

same size as the paper in the tray selected for copying.

48

PAPER USED.

 

 

 

 

 

TONER SUPPLY IS LOW.

The toner cartridge must be replaced soon.

74

 

 

 

CHANGE THE TONER CARTRIDGE.

The toner cartridge is out of toner. Replace the toner cartridge.

74

 

 

 

CHECK THE TONER CARTRIDGE.

Make sure that the toner cartridge is installed correctly.

74

 

 

 

THE DOCUMENT FEEDER IS

The RSPF has been disabled in the key operator programs. Use

22

DISABLED.

the document glass.

 

 

 

 

SELECTED PAPER TRAY IS

This appears when a tray is selected that has been prohibited in

 

PROHIBITED. PLEASE SELECT

"TRAY SETTINGS" in the custom settings.

55

ANOTHER PAPER TRAY.

 

 

 

 

 

PLEASE CHECK THE PAPER

The tray's paper size setting is different from the actual paper size.

15

SIZE OF TRAY <***>.

Load the correct size of paper. The tray is indicated in <***>.

 

 

 

 

ADD STAPLES.

The finisher is out of staples. Replace the staple cartridge as

75

 

explained in "STAPLE CARTRIDGE REPLACEMENT".

 

 

 

 

 

PLEASE REMOVE PAPER FROM

Paper remains in the stapler compiler. Remove the paper.

72

THE STAPLER COMPILER.

 

 

 

 

 

 

MEMORY IS FULL. PRESS [START]

The memory becomes full while scanning originals. Press the

 

TO BEGIN COPYING OR [CA] TO

[START] key ( ) to copy only the originals that have been

-

CANCEL.

scanned, or press the [CLEAR ALL] key ( ) to cancel the job.

 

 

 

 

60