PROGRAMS FOR PRINT MODE

ENABLE EtherTalk

This program must be enabled to use the machine on a network that uses EtherTalk protocol.

This program is initially enabled (factory default setting).

ENABLE NetBEUI

This program must be enabled to use the machine on a network that uses NetBEUI protocol.

This program is initially enabled (factory default setting).

RESET THE NIC *1

This program is used to restore all network settings to the factory default settings.

INITIALIZE AND/OR STORE SETTINGS

(When the PRINTER EXPANSION KIT is installed)

These programs are used to return the configuration settings (See the online manual for network printer) and the "PRINT SETTINGS" (p.16) to the factory default settings. The programs are also used to store the current settings and to restore stored settings. "INITIALIZE AND/OR STORE SETTINGS" consists of the following programs:

●RESTORE FACTORY DEFAULTS

●STORE CURRENT CONFIGURATION

●RESTORE CONFIGURATION

Some programs in the following are marked Note by "*1". This indicates that a message will

appear at the end of the setting procedure asking you to confirm execution of the new setting. If needed, you can cancel the new setting by touching the [NO] key.

RESTORE FACTORY DEFAULTS *1

This program is used to return the configuration settings (see the online manual for network printer) and the "PRINT SETTINGS" (p.16) to the factory default settings. If you need a record of the current settings before restoring the factory defaults, use "Data list print" in the user settings to print a list of the current settings. (See "CUSTOM SETTINGS" in the operation manual for copier.)

STORE CURRENT CONFIGURATION *1

This program is used to store the current configuration settings (see online manual for network printer) and "PRINT SETTINGS" (p.16). The stored settings will not be erased even if the power is turned off. To restore the stored settings, use the "RESTORE CONFIGURATION" program.

RESTORE CONFIGURATION *1

This program is used to restore settings that were stored using the "STORE CURRENT CONFIGURATION" program.

The current settings will change to the restored settings.

If any of the "NETWORK SETTINGS" (p.18) Note were changed before execution of this

program, you must turn off the machine’s power switch, wait briefly, and then turn the switch back on in order to make the settings take effect.

19