Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface

Datasheet

8.5.5PIO Burst Reads

In this mode, performance is improved by allowing up to 16 WORD read cycles back-to-back. PIO burst reads can be performed using Chip Select (nCS) or Read Enable (nRD). A PIO Burst Read begins when both nCS and nRD are asserted. Either or both of these control signals must de-assert between bursts for the period specified in Table 15.9, “PIO Burst Read Cycle Timing Values,” on page 449. The burst cycle ends when either or both nCS and nRD are de-asserted. They may be asserted and de-asserted in any order. Read data is valid as indicated in the functional timing diagram in Figure 8.4.

Note: A[1] must toggle during burst reads. Fresh data is supplied each time A[1] is toggled.

The endian select signal (END_SEL) has the same timing characteristics as the upper address lines.

Please refer to Section 15.5.5, "PIO Burst Read Cycle Timing," on page 449 for the AC timing specifications for PIO burst read operations.

Note: PIO burst reads are only supported for the RX Data FIFO. Burst reads from other registers are not supported.

END_SEL

 

VALID

 

 

 

A[x:5]

 

VALID

 

 

 

A[4:1]

VALID

VALID

VALID

 

VALID

nCS, nRD

 

 

 

 

 

D[15:0] (OUTPUT)

VALID

 

VALID

VALID

VALID

Figure 8.4 Functional Timing for PIO Burst Read Operation

Revision 1.4 (08-19-08)

108

SMSC LAN9311/LAN9311i

 

DATASHEET