Two Port 10/100 Managed Ethernet Switch with
Datasheet
14.5.3.21Switch Engine Port Mirroring Register (SWE_PORT_MIRROR)Register #: | 1846h | Size: | 32 bits |
This register is used to configure port mirroring.
BITS |
| DESCRIPTION | TYPE | DEFAULT |
|
|
|
| |
31:9 | RESERVED | RO | - | |
|
|
|
| |
8 | Enable RX Mirroring Filtered | R/W | 0b | |
| When set, packets that would normally have been filtered are included in the |
|
| |
| receive mirroring function and are sent only to the sniffer port. When |
|
| |
| cleared, filtered packets are not mirrored. |
|
| |
| Note: | The Ingress Filtered Count Registers will still count these packets |
|
|
|
| as filtered and the Switch Engine Interrupt Pending Register |
|
|
|
| (SWE_IPR) will still register a drop interrupt. |
|
|
|
|
|
| |
7:5 | Sniffer Port | R/W | 00b | |
| These bits specify the sniffer port that transmits packets that are monitored. |
|
| |
| Bits 7,6,5 correspond to switch ports 2,1,0 respectively. |
|
| |
| Note: | Only one port should be set as the sniffer. |
|
|
|
|
|
| |
4:2 | Mirrored Port | R/W | 00b | |
| These bits specify if a port is to be mirrored. Bits 4,3,2 correspond to switch |
|
| |
| ports 2,1,0 respectively. |
|
| |
| Note: | Multiple ports can be set as mirrored. |
|
|
|
|
|
| |
1 | Enable RX Mirroring | R/W | 0b | |
| This bit enables packets received on the mirrored ports to be also sent to |
|
| |
| the sniffer port. |
|
| |
|
|
|
| |
0 | Enable TX Mirroring | R/W | 0b | |
| This bit enables packets transmitted on the mirrored ports to be also sent to |
|
| |
| the sniffer port. |
|
| |
|
|
|
|
|
SMSC LAN9311/LAN9311i | 391 | Revision 1.4 |
| DATASHEET |
|