Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface

Datasheet

14.2.3.4LED Configuration Register (LED_CFG)

Offset:

1BCh

Size:

32 bits

This read/write register configures the GPIO[7:0] pins as LED[7:0] pins and sets their functionality.

BITS

DESCRIPTION

TYPE

DEFAULT

 

 

 

 

31:10

RESERVED

RO

-

 

 

 

 

9:8

LED Function 1-0 (LED_FUN[1:0])

R/W

Note 14.2

 

These bits control the function associated with each LED pin as shown in

 

 

 

Table 13.1 of Section 13.3, "LED Operation," on page 165.

 

 

 

Note: In order for these assignments to be valid, the particular pin must

 

 

 

be enabled as an LED output pin via the LED_EN[7:0] bits of this

 

 

 

register.

 

 

 

 

 

 

7:0

LED Enable 7-0 (LED_EN[7:0])

R/W

Note 14.3

 

This field toggles the functionality of the GPIO[7:0] pins between GPIO and

 

 

 

LED.

 

 

 

0: Enables the associated pin as a GPIO signal

 

 

 

1: Enables the associated pin as a LED output

 

 

 

 

 

 

Note 14.2 The default value of this field is determined by the configuration strap LED_fun_strap[1:0]. Configuration strap values are latched on power-on reset or nRST de-assertion. Some configuration straps can be overridden by values from the EEPROM Loader. Refer to Section 4.2.4, "Configuration Straps," on page 40 for more information.

Note 14.3 The default value of this field is determined by the configuration strap LED_en_strap[7:0]. Configuration strap values are latched on power-on reset or nRST de-assertion. Some configuration straps can be overridden by values from the EEPROM Loader. Refer to Section 4.2.4, "Configuration Straps," on page 40 for more information.

SMSC LAN9311/LAN9311i

197

Revision 1.4 (08-19-08)

 

DATASHEET