SMSC LAN9311, LAN9311i Chapter 14 Register Descriptions

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface

Datasheet

Chapter 14 Register Descriptions

This section describes the various LAN9311/LAN9311i control and status registers (CSR’s). These registers are broken into 5 categories. The following sections detail the functionality and accessibility of all the LAN9311/LAN9311i registers within each category:

„Section 14.1, "TX/RX FIFO Ports," on page 168

„Section 14.2, "System Control and Status Registers," on page 169

„Section 14.3, "Host MAC Control and Status Registers," on page 271

„Section 14.4, "Ethernet PHY Control and Status Registers," on page 287

„Section 14.5, "Switch Fabric Control and Status Registers," on page 309

Figure 14.1 contains an overall base register memory map of the LAN9311/LAN9311i. This memory map is not drawn to scale, and should be used for general reference only.

Note: Register bit type definitions are provided in Section 1.3, "Register Nomenclature," on page 19.

Note: Not all LAN9311/LAN9311i registers are memory mapped or directly addressable. For details on the accessibility of the various LAN9311/LAN9311i registers, refer the register sub-sections listed above.

3FFh
...	RESERVED
2E0h
2DCh	Switch CSR Direct Data
...
	Registers
200h
1DCh
	Virtual PHY Registers
1C0h
1B0h
	Switch Interface Registers
1ACh
19Ch	1588 Registers
100h
0A8h
	Host MAC Interface Registers
0A4h
050h
04Ch	TX Status FIFO PEEK
048h	TX Status FIFO Port
044h	RX Status FIFO PEEK
040h	RX Status FIFO Port
03Ch	TX Data FIFO Port
020h	& Alias Ports
01Ch	RX Data FIFO Port
Base + 000h	& Alias Ports

CSRs System

FIFOs TX/RX

Figure 14.1 LAN9311/LAN9311i Base Register Memory Map

SMSC LAN9311/LAN9311i	167	Revision 1.4 (08-19-08)
	DATASHEET