SMSC LAN9311, LAN9311i 10.2.4EEPROM Loader, 10.2.4.1EEPROM Loader Operation

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface

Datasheet

10.2.4EEPROM Loader

The EEPROM Loader interfaces to the I2C/Microwire EEPROM controller, the PHYs, and to the system CSRs (via the Register Access MUX). Only system CSRs at addresses 100h and above are accessible to the EEPROM Loader (with the addition of the PHY Management Interface Data Register (PMI_DATA) and PHY Management Interface Access Register (PMI_ACCESS) at addresses A4 and A8 respectively).

The EEPROM Loader runs upon a pin reset (nRST), power-on reset (POR), digital reset (DIGITAL_RST bit in the Reset Control Register (RESET_CTL)), or upon the issuance of a RELOAD command via the EEPROM Command Register (E2P_CMD). A soft reset will run the EEPROM Loader, but only the MAC address is loaded into the Host MAC. Refer to Section 4.2, "Resets," on page 36 for additional information on the LAN9311/LAN9311i resets.

The EEPROM contents must be loaded in a specific format for use with the EEPROM Loader. An overview of the EEPROM content format is shown in Table 10.7. Each section of EEPROM contents is discussed in detail in the following sections.

Table 10.7 EEPROM Contents Format Overview

EEPROM ADDRESS	DESCRIPTION	VALUE
0	EEPROM Valid Flag	A5h
1	MAC Address Low Word [7:0]	1st Byte on the Network
2	MAC Address Low Word [15:8]	2nd Byte on the Network
3	MAC Address Low Word [23:16]	3rd Byte on the Network
4	MAC Address Low Word [31:24]	4th Byte on the Network
5	MAC Address High Word [7:0]	5th Byte on the Network
6	MAC Address High Word [15:8]	6th Byte on the Network
7	Configuration Strap Values Valid Flag	A5h
8 - 11	Configuration Strap Values	See Table 10.8
12	Burst Sequence Valid Flag	A5h
13	Number of Bursts	See Section 10.2.4.5,
		"Register Data"
14 and above	Burst Data	See Section 10.2.4.5,
		"Register Data"

10.2.4.1EEPROM Loader Operation

Upon a pin reset (nRST), power-on reset (POR), digital reset (DIGITAL_RST bit in the Reset Control Register (RESET_CTL)), or upon the issuance of a RELOAD command via the EEPROM Command Register (E2P_CMD), the EPC_BUSY bit in the EEPROM Command Register (E2P_CMD) will be set. While the EEPROM Loader is active, the READY bit of the Hardware Configuration Register (HW_CFG) and Power Management Control Register (PMT_CTRL) is cleared and no writes to the LAN9311/LAN9311i should be attempted. The operational flow of the EEPROM Loader can be seen in Figure 10.14.

Revision 1.4 (08-19-08)	150	SMSC LAN9311/LAN9311i
	DATASHEET