Note that the setup data in RAM can also be saved to the control panel hard disk or memory card.

Panel Setup

In panel setup, you carry out settings particular to the control panel.

You can make the following settings.

For details of the operations, see “Setup Relating to Operations From the Control Panel” in Chapter 16 (Volume 2).

Panel settings (Config)

•M/E Assign: Set the logical configuration of the M/E and P/P banks.

•M/E Operation: For each of the M/E and P/P banks, make operations possible, not possible, or disabled (Enable/Disable/Inhibit).

•DSK Fader Assign: Carry out fader function assignment and key delegation for the key delegation buttons.

•External Bus Link: Make link settings relating switcher cross-point buttons to routing switcher sources.

•Key Trans Link: Select whether or not to link transitions between keyers, and if so which keyer to link to. You can set the links between keyers for each M/E bank separately.

Cross-point button settings (Xpt Assign)

•Multi Xpt Assign: For each operating bank or bus, assign a main table and “sub” tables 1 to 4.

•Xpt Assign: Carry out main table settings.

•Assign video/key sources for button numbers.

•Set source names of up to sixteen characters.

•Set the LCD color for source name display.

•For each cross-point table, specify whether the rightmost cross-point button in each row is used as a shift button, and the operating mode when it is used as a shift button.

•Sub Table Assign: For sub tables 1 to 4, set rearrangements of the button layout set in the main table. Also set the shift button mode.

•Shift Mode: For the [SHIFT] button in the cross-point control block, select the mode in which this is a shift button dedicated to the source display section, or the mode in which it is a shift button for all buses.

AUX bus settings (Aux Assign)

•Aux Assign: Assign the AUX delegation buttons in the AUX bus control block to any bus.

Functions 9000-DVS 1 Chapter

Setup 127