Panel Control and Menus 2 Chapter

The number of valid buttons depends on the number of DME processor channels installed.

Note

In the DVS-9000 system, DME5 to DME8 are not available.

When the [DEV] button is selected: This enables the VTR operation mode in the device control block. In this state, the [M/E 1] and [M/E 2] buttons function as the device 1 and device 2 allocation buttons.

To exit from this mode, press the [DEV] button again, turning it off.

When the [RUN CTRL] button is selected: This enables the effect run control mode in the device control block.

The functions of the operation buttons, trackball, and Z-ring vary with the operation mode as follows.

bOperation buttons

When the positioner operation mode is enabled

K1 CB1: Press this button to enable wipe pattern position setting for key 1 (DSK1).

When the [USER] button is selected, pattern position setting for color background 1 is enabled.

K2 CB2: Press this button to enable wipe pattern position setting for key 2 (DSK2).

When the [USER] button is selected, pattern position setting is enabled for color background 2.

K3 FM1: Press this button to enable wipe pattern position setting for key 3 (DSK3).

When the [USER] button is selected,

pattern position setting is enabled for frame memory 1.

K4 FM2: Press this button to enable wipe pattern position setting for key 4 (DSK4).

When the [USER] button is selected, pattern position setting is enabled for frame memory 2.

MAIN: Press this button to enable main wipe pattern position setting for normal transitions.

SUB: Press this button to enable sub wipe pattern position setting for normal transitions.

Among the [K1 CB1] button, [K2 CB2] button, [K3 FM1] button, [K4 FM2] button, [MAIN] button, and [SUB] button, you can make a multiple selection.

POS: Press this button to enable pattern movement in the x-axis and y-axis directions with the trackball.

When the [USER] button is selected, this enables the trackball to move the pattern in the x-axis and y-axis directions, and the Z-ring to adjust the size of the pattern.

X, Y: These restrict the axes affected by the trackball and Z-ring to the x- or y-axis. They also allow entry of a numeric value for the corresponding axis using the numeric keypad control block.

Z:When the [USER] button is selected, this restricts the axes affected by the trackball and Z-ring to the z-axis. It also allows entry of a numeric value for the z-axis using the numeric keypad control block.

CTR (center): When this button is pressed, the pattern position returns to the center. When the [USER] button is selected, the pattern size also returns to 50.00.

SHIFT/CLR WORK BUFR: These are not used in positioner operation mode.

148 Names and Functions of Parts of the Control Panel