Panel Control and Menus 2 Chapter

TRGT (STOP): Press this button to stop the tape.

AXIS LOC (START TC: start timecode): Press this button to set the timecode of the start point. Each time you press the button, the start point changes.

ASP PERS (STOP TC: stop timecode): Press this button to set the timecode of the stop point. Each time you press the button, the stop point changes.

LOC SIZE (VAR: variable speed playback): Pressing this button and turning the Z-ring plays back the tape at a variable speed and direction proportional to the rotation angle of the Z-ring. The variable speed range is –1 to +3 times normal playback speed.

LOC XYZ (SHTL: shuttle): Pressing this button and turning the Z-ring plays back the tape at a speed and direction proportional to the rotation angle of the Z-ring.

ROT (JOG): Pressing this button and turning the Z-ring plays back the tape at a speed and direction proportional to the rotation speed and direction of the Z-ring.

CLR WORK BUFR (CUE): Pressing this button cues the tape automatically to the start point.

X (REW: rewind): Press this button to rewind the tape.

Y (PLAY): Press this button to play the tape.

Z (FF): Press this button to fast-forward the tape.

CTR (ALL STOP): Press this button to stop all tape transport operations.

3Trackball

When the positioner operation mode is enabled

By moving this, you can move the pattern in the x-axis and y-axis directions.

When the three-dimensional transform operation mode is enabled

Move the trackball to control the x- and y- axes in a three-dimensional transform.

4Z-ring

When the positioner operation mode is enabled

When the [USER] button is selected, by turning the ring you can adjust the size of the pattern.

When the three-dimensional transform operation mode is enabled

Turn this ring to control the z-axis in a three-dimensional transform.

When the effect run control mode is enabled

By turning the Z-ring, you can run the keyframe effect, independent of the STOP NEXT KF, EFF LOOP, and similar settings in the keyframe control block. Turn clockwise to run the effect in the normal direction, and counterclockwise for the reverse direction.

When the VTR operation mode is enabled

Turning the Z-ring controls the tape transport, at a speed determined by the operating buttons. Turn clockwise for the normal direction, and counterclockwise for the reverse direction.

5MENU button

Press this button, turning it on, to enable adjusting the parameters allocated to the knobs in the menu using the trackball and Z-ring.

In the case of the DME menu, the operation applies to the selected DME channel.

150 Names and Functions of Parts of the Control Panel