Wipes DME 6 Chapter

Basic Procedure for DME Wipe Settings

You carry out DME wipe setting operations principally using the DME Wipe menu for each of the M/E-1 and PGM/PST banks.

This section describes the basic procedures for DME wipe settings, taking the M/E-1> DME Wipe menu as an example.

Note

To carry out DME wipes requires the BKDS-9470 DME Board Set.

For details of independent key transition DME wipe settings, see “DME Wipe Settings for Independent Key Transitions” (page 263).

DME Wipe Settings Menu

Accessing the DME Wipe menu

To access the M/E-1> DME Wipe menu, use any of the following operations.

•In the menu control block, select the top menu selection button [M/E 1], and press VF6 ‘DME Wipe.’

•In the transition control block of the M/E-1 bank, press the transition type selection button [DME] twice in rapid succession.

Any of the above operations displays the M/E-1>DME Wipe menu.

DME Wipe Pattern Selection

You can select a DME wipe pattern in the DME Wipe menu.

Selecting a DME wipe pattern by a menu operation

Use the following procedure.

1 In the M/E-1>DME Wipe menu, select HF1 ‘1ch’ for one-channel mode or HF2 ‘2ch’ for two-channel mode.

260 Basic Procedure for DME Wipe Settings