For an overview of the auto transition, see page 33.
To carry out an instantaneous cut transition: Press the [CUT] button.
To carry out a gradual transition: Press the [AUTO TRANS] button. This executes the transition at the preset transition rate (see page 188). While the transition is executing, the [AUTO TRANS] button lights amber. When it completes the button goes off.
To complete a partially executed transition instantaneously: Press the [CUT] button.
The [AUTO TRANS] button goes off.
Executing a Transition With the Fader Lever (Manual Transition)
To execute a manual transition with the transition control block fader lever, use the following procedure.
For an overview of the manual transition, see page 33.
To carry out the transition completely: Move the lever over the full range of its travel.
To pause a partly executed transition: Stop moving the fader lever.
To resume a paused transition: Resume moving the fader lever.
Combinations of Auto and Manual Transitions
Using the [AUTO TRANS] button, the [CUT] button, and the fader lever, use the following procedures.
Moving the fader lever during an auto transition
During an auto transition started by pressing the [AUTO TRANS] button, operating the fader lever immediately enables the fader lever, and the [AUTO TRANS] button goes off. Thereafter, the fader lever controls the progress of the transition.
Executing an auto transition after partly moving the fader lever
•Press the [CUT] button to instantaneously complete the transition.
•Press the [AUTO TRANS] button to complete the rest of the transition at the preset transition rate.
Transitions 3 Chapter
Executing a Transition 193