2 Press the [Pattern Limit] button, turning it on.

3 Adjust the following parameters.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Pattern Limit

Pattern limit

0.00 a) to 100.00% b)

2 c)

Transition rate

Transition rate

0 to 999 (frames)

a)0.00%: Executing the transition does not change the video output at all.

b)100.00%: The transition is the same as when no pattern limit is set, but the cross-point button selections of the background A and B buses do not interchange when the transition completes.

c)This only appears when the Setup setting is made so that the transition is executed the instant that the pattern limit is released. (See “Settings Relating to Keys, Wipes and Frame Memory (Key/Wipe/FM Menu)” in Chapter 16 (Volume 2).)

Executing a pattern limit transition

Use the following procedure.

1 Press the [PTN LIMIT] button, turning it on.

The button you pressed lights amber.

2 Carry out the transition.

The transition progresses as far as the set pattern limit. Even if the transition completes, the cross-point button assignments of the background A and B buses do not interchange.

3 Carry out the transition once again.

The status before the previous transition is restored.

To cancel the pattern limit

To cancel the pattern limit after completion of step 3 of the above procedure, press the [PTN LIMIT] button, turning it off.

If after carrying out step 2 above, the pattern limit has been reached, carry out the following procedure.

1 Press the [PTN LIMIT] button.

The button you pressed lights green.

2 Carry out the transition.

The [PTN LIMIT] button goes off, and the pattern limit state is released. Depending on the way in which the transition was executed, the action will be as follows.

Transitions 3 Chapter

Executing a Transition 191