Wipes 5 Chapter

Wipe Settings for Independent Key Transitions

You carry out independent key/downstream key transition wipe setting operations using the Wipe Adjust menu for each keyer.

For an overview of independent key transitions, see page 26.

This section describes the independent key transition wipe settings, taking the M/E-1>Key1>Transition>Wipe Adjust menu as an example.

Basic Procedure for Independent Key Transition Wipe Settings

Accessing the independent key transition wipe settings menu

As an example, to access the M/E-1>Key1>Transition>Wipe Adjust menu, carry out the following operation.

• In the menu control block, select the top menu selection button [M/E 1] and select VF1 ‘Key1’ and HF6 ‘Transition’ to display the Transition menu for key 1, then press [Wipe Adjust].

Carrying out the above operation displays the M/E-1>Key1>Transition>Wipe Adjust menu (which will be referred to below as simply the Key1 Wipe Adjust menu).

Selecting the independent key transition wipe pattern

You select the independent key wipe pattern from the list of patterns displayed in the menu.

Note

In an independent key transition, you can only use the standard wipe patterns (pattern numbers 1 to 24).

To select a wipe pattern for independent key1 on the M/E-1 bank, use the following procedure.

1 In the Key1 Wipe Adjust menu, select [Pattern Select].

The Pattern Select menu appears.

254 Wipe Settings for Independent Key Transitions