Panel Control and Menus 2 Chapter
REV (reverse): The wipe proceeds in the opposite direction to that when the [NORM] button is pressed.
NORM/REV (normal/reverse): The wipe direction alternates between normal and reverse every time a transition is executed.
eTRANS PVW (transition preview) button
When this button is lit, you can check in advance the video changes during the transition, on the preview output from the M/E or PGM/PST bank.
During the preview, you can use the fader lever, [AUTO TRANS] button, and [CUT] button. One of the following functions of this button can be selected in a Setup mode.
•When the transition completes, the system returns to the normal mode.
•The transition preview mode is maintained while this button is pressed.
•Switching is made between the transition preview mode and normal mode every time this button is pressed.
fPattern limit buttons
LIMIT SET: Use this button to set a pattern limit when the [PTN LIMIT] button is off.
Move the fader lever to the position of a particular pattern size, and stop it there, then press this button to set the pattern limit range.
PTN (pattern) LIMIT: Pressing this button, turning it on, enables the pattern limit function.
gKey status display
For each of keys 1 to 4, the corresponding ON indicator lights when the key is inserted. It also shows the priority (1 to 4) of each key.
hPRIOR (priority) SET button While this button is held down, you can set the key priority.
The setting mode when this button is pressed depends on whether or not the [KEY PRIOR] button is lit, as follows.
• When the [KEY PRIOR] button is off, the current key priority is set.
• When the [KEY PRIOR] button is lit, the key priority after the next transition is set.
Press the [KEY PRIOR] button as required, to switch between these two modes.
In either mode, hold down the [PRIOR SET] button, and press the button ([KEY1] to [KEY4]) corresponding to the key you want to bring to the front.
iKF (keyframe) button
The following controls are used as the independent key transition control block.
jIndependent key/downstream key
transition execution section KEY1 TRANS to KEY4 TRANS (DSK1
TRANS to DSK4 TRANS in the PGM/PST bank) buttons: These correspond to keys 1 to 4 from left to right; press one to carry out an auto transition. The transition rate for an independent key transition can be set in the numeric keypad control block or in a menu.
142 Names and Functions of Parts of the Control Panel