Parallel port settings (Parallel Tally)

Make the parallel port settings for output of tally information pertaining to sources and destinations.

For each of the tally output terminal numbers, specify the tally type, and source address or destination level and address.

Simple Connection to MKS-8080/8082 AUX Bus Remote Panel (Option)

To connect the MKS-8080/8082 AUX Bus Remote Panel to a CCP-9000 Center Control Panel using an S-BUS data link requires a BKPF-R70A Routing Switcher Controller Board or similar primary station and various settings for connection.

However, using a simple connection, the need for an S-BUS data link primary station is avoided, and direct connection to the MKS-8080/8082 is possible. A simple connection is possible if the following conditions are met:

•There are no devices other than the CCP-9000 and MKS-8080/8082 connected on the S-BUS data link.

•There are no more than sixteen MKS-8080/8082 units connected on the S- BUS data link.

For details of the connection procedure, see “Procedure for Simple

Connection” in Chapter 16 (Volume 2).

Functions 9000-DVS 1 Chapter

Setup 133