Star Micronics NX-15 user manual Crt

		111
	Table 7-3
	Alternative graphics commands
Density	Single command	Individual command
Noraml	(ESC)”*” CHR$(0)nl n2	(E7CJC)<’K”Z1n2 ml m2 ...
	ml m2 ...
Double	(ESC)”*” CHR$(l) %1nz	(ESC)<<L’>nl YZ2ml WZ2...
	ml m2 ...

Doublewith (ESC)”*” CHR$(2)nl n2 (ESC>’’~,,~~ ~z m] mz ...

double-speedml m2 ...

Quadruple ::s:;’:” CHR$(3)nl %2 (ESC)’”Z”nl nz ml mz ...

CRT	(ESC)’’~;’CHR$(4)nl n2		none
	ml	m2 ...
Plotter	(ESC)”*” CHR$(5)nl n2		*one
	ml	m2 ...

CRT type II <ESC>”*”CHR$(6)nl n.2 none

ml m2 ...

MORE GRAPHICS PROGRAMMING TIPS

At the end of this chapter, we’ll discuss two modes that the printer offers to help you solve potential graphics problems. A redefining code allows you to change the density for graphics programs that use one of the four alternate codes. The 9-pin graphics mode allows you to use all nine pins on each line and thus speed up screen dumps.

Table 7-4

More graphics commands

Function	Control code
Redefinethe graphics mode	(ESC)”?” nOnl
9-pingraphics	~Esc>” ->> nOnl n2 ml m2

■Redefining alternate graphics codes

Your printer provides a command to redefine one of the alter- nate graphics modes — K, L, Y, or Z —so that it represents any other of the seven graphics modes. The command is (ESC) “?” nOnl, where nOis one of the four letters, “K”, “L”, “Y”, or “Z”, and nl is one of the numbers used with the (ESC) “*” com- mand, Oto 6. There are several instances in which you may use this sequence.