
I_
189
The printer will report that it has run out of paper by making the PAPER OUT signal on pin 12 high. This pin can be held low by turning DIP switch
Table
Parallel interface pin functions
Pin No. | ~i:;:l |
Direction | |
1 | STROBE IN |
Function
Signals when data is ready to be read. Signal goes from HIGH to LOW (for at least 0.5 microseconds) when data is available.
2 | DATA1 | IN |
3 | DATA2 | IN |
4 | DATA3 | IN |
5 | DATA4 | IN |
6 | DATA5 | IN |
7 | DATA6 | IN |
8 | DATA7 | IN |
9 | DATA8 | IN |
10 | ACK | OUT |
These signals provide the information of the first to eighth bits of parallel data. Each signal is at HIGH level for a logical
. 1 and at a LOW level for a logical O.
ALOW pulse
11 | BUSY | OUT | When this signal goes LOW the printer is |
|
|
| ready to accept data. |
12 PAPER OUT OUT
13 SELECTED OUT
16SIGNAL GND
17CHASSIS GND
18“+ 5VDC OUT
31RESET IN
This signal is normally LOW. It will go HIGH if the printer runs out of paper. This signal can be held LOW permanent ly by turning DIP switch
This signal is HIGH when the printer is
Unused Signal ground.
Printer’s chassis ground, isolated from logic mound.
External supply of + 5VDC.
Twisted pair return signal ground level.
When this signal goes LOW the printer is reset to its
32 | ERROR | OUT | This signal is normally HIGH. This | |
II |
| I | signal goes LOW to signal that the | |
| [pfinter~annot Print duetoan error | |||
ad | L,’x L “L. LJ |
| UALLLI. | CI, & |
34, 35 | NIC |
| Unused. | |
136 | SELECTIN | I | Data entm to the printer is possible only | |
I | I | Iwhen | this_ level is LOW. | |
1 | I | 1 | 1 |
|