FederalCommunicationsCommission

RadioFr uencyInterference %tatement

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause in- terference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Subpart J of Part 15of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

. Reorient the receiving antenna

. Relocate the computer with respect to the receiver

. Move the computer away from the receiver

Plug the computer into a different outlet so that computer and receiver are on dif- ferent branch circuits.

If necessary the user should consult the dealer or an experienced radio/television techni- cian for additional suggestions. The user may find the following booklet, prepared by the Federal CommunicationsCommissionhelpful: “How to Identify and Resolve Radio- TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.

For com~liance with Federal Noise Interference Standard, this equipment requires a shielded cable.

This stitement will be appliedonlyfbr tb printers mrtited in L%S.A.

Self Declaration

Radio interferences regarding this equipment has been eliminated according to Vfg 1046/1984announced by the DBP.

DBP has been informed about the introduction of this special equipment and has been conceded the right to examine the whole series.

It is upon the responsibility of the user to assume that his own assembled system is in ac- cordance with the technical regulations under Vfg 1046/1984.

To observe FTZ-regulations it is necessary, to establish all connections to the printer with shielded cable.

The equipment may only be opened by qualified service representatives.

This shtement will be a#lied onlyfor the~n”ntersmarketedin West @many.

TrademarkAcknowledgement

NX-15:Star Micronics Co., Ltd.

Apple II: Apple Computer Inc.

EasyWriterII: Information Unlimited Software, Inc.

FX-85: Seiko Epson Corp.

IBM PC, IBM GraphicsPrinter:International Business Machines Corp.

Lotus1-2-3:Lotus Development Corp.

MicrosoftBASIC: Microsoft Cornoration

WordStar:MicroPro International Corporation

NOTICE

.All rights reserved. Reproduction of any part of this manual in any form what-

soever, without STAR’Sexpress permission is forbidden.

. The contents of this manual are subject to change without notice.

QAll efforts have been made to ensure the accuracy of the contents of this manual at the time of going to press. However, should any errQrs be detected, STAR would be greatly appreciate being informed of them.

The above notwithstiding, STAR can assume no responsibility for any errors in this manual.

@COPWi~ht 1986 Star Micronics CO., Ltd.

Page 2
Image 2
Star Micronics NX-15 user manual Self Declaration