![](/images/new-backgrounds/1186275/186275401x1.webp)
TABLE H-30 lists the arguments for this subcommand.
TABLE H-30 Arguments for Subcommand sp set jnet
ArgumentDescription
Specifies the IP address for the SP. |
Note – If you change the default addresses of JNET using this command and then
sp reset to
Otherwise, the connection will be
Return Codes
TABLE H-31 lists the return codes for this subcommand.
TABLE H-31 Return Codes for Subcommand sp set jnet
Return Code | ID | Description |
|
|
|
NWSE_Success | 0 | Command successfully completed. |
NWSE_InvalidUsage | 1 | Invalid usage: bad parameter usage, conflicting options |
|
| specified. |
NWSE_NoPermission | 6 | Not authorized to perform this operation. |
NWSE_NoMemory | 8 | Insufficient memory. |
NWSE_Busy | 9 | Device or resource is busy. |
NWSE_HostDown | 14 | Host is down. |
|
|
|
Appendix H Service Processor Commands 179