Sun Microsystems V20Z SP Get Port 80 Subcommand, Table H-42Arguments for Subcommand sp get port80

Return Codes

TABLE H-41lists the return codes for this command.

TABLE H-41Return Codes for Subcommand sp create test events

Return Code	ID	Description
NWSE_Success	0	Command successfully completed.
NWSE_InvalidUsage	1	Invalid usage: bad parameter usage, conflicting options
		specified.
NWSE_RPCTimeout	2	Request was issued, but was not serviced by the server.
		RPC procedure timed out and the request may or may
		not have been serviced by the server.
NWSE_NoMemory	8	Insufficient memory.

SP Get Port 80 Subcommand

Description: Retrieves the last Port 80 post code from the PRS Port80 register. The register is written by platform BIOS during platform boot. This command is used to debug platform boot problems.

Format

Command format:

sp get port80 {-m --monitor}

TABLE H-42lists the arguments for this subcommand.

TABLE H-42Arguments for Subcommand sp get port80

ArgumentDescription

{-m --monitor}Allows for continuous monitoring of the port 80 traffic.

You can also retrieve the last ten Port 80 post codes using the operator panel.

For more details about using the operator-panel menus, refer to the Sun Fire V20z Server User Guide (817-5248-xx).

See TABLE H-44for a list of the Power On Self Test (POST) codes for the Phoenix BIOS.

See TABLE H-45for a list of the boot block codes on Flash ROM.

186 Sun Fire V20z and Sun Fire V40z Servers, Server Management Guide • May, 2004