Assigning Static SP Network Settings
Follow these steps to set the SP network settings using a static IP address. You must specify a subnet mask and default gateway. This example uses the following sample settings:
IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.254
1.Press any operator panel button on the server front panel (see FIGURE
Menu: Server Menu
2.Press the Forward operator panel button until you reach the SP menu:
Menu: SP menu
3.Press the Select operator panel button to display the SP menu options.
SP Menu:
Set SP IP info?
4.Press the Select operator panel button. The following prompt displays with the default response:
SP use DHCP? No
5.Press the Select operator panel button. The LCD displays as follows:
SP IP Address:
0.0.0.0
6.With the cursor in the first field, increase or decrease the value using the Back and Forward operator panel buttons.
This field can hold a value between 0 and 255.
SP IP Address:
10.0.0.0
7.After reaching your desired value, press the Select operator panel button to advance the cursor to the next field.
SP IP Address: 10.0.0.0
Chapter 1 Introduction 11