Sun Microsystems V20Z, V40z manual 2Expressions and Parameters for IPMItool 3

TABLE 2-2Expressions and Parameters for IPMItool (3 of 4)

Expression	Parameter	Sub-parameter	Description and examples
power			Performs a chassis control command to view and change
			the power state.
	status		Shows the current status of the chassis power.
	on		Powers on the chassis.
	off		Powers off chassis into the soft off state (S4/S5 state).
			NOTE: This command does not initiate a clean shutdown
			of the operating system prior to powering off the server.
	cycle		Provides a power-off interval of at least 1 second.
			No action should occur if chassis power is in S4/S5 state,
			but it is recommended to check the power state first and
			then only issue a power-cycle command if the server
			power is on or in a lower sleep state than S4/S5.
	reset		Performs a hard reset.
lan	print	channel	Prints the current configuration for the given channel.
	set	channel	Sets the given parameter on the given channel.
		parameter
		ipaddr x.x.x.x	Sets the IP address for this channel.
		netmask x.x.x.x	Sets the netmask for this channel.
		macaddr	Sets the MAC adddress for this channel.
		xx:xx:xx:xx:xx:xx
		defgw ipaddr	Sets the default gateway IP address.
		x.x.x.x
		defgw macaddr	Sets the default gateway MAC address.
		xx:xx:xx:xx:xx:xx
		bakgw ipaddr	Sets the backup gateway IP address.
		x.x.x.x
		bakgw macaddr	Sets the backup gateway MAC address.
		xx:xx:xx:xx:xx:xx
		password pass	Sets the null user password.
		user	Enables the user-access mode.
		access [onoff]	Sets the LAN-channel-access mode.
		ipsrc source	Sets the IP address source. As a source, you can indicate:
			none = unspecified
			static = manually configured static IP address
			dhcp = address obtained by BMC running DHCP
			bios = address loaded by BIOS or system software

34 Sun Fire V20z and Sun Fire V40z Servers, Server Management Guide • May, 2004