SP Set Locatelight Subcommand
Description: Sets the state of the locatelight switch (which describes the state of the front and rear panel identification lights).
Format
Command format:
sp set locatelight {blink off}
Return Codes
TABLE H-34 lists the return codes for this subcommand.
TABLE H-34 Return Codes for Subcommand sp set locatelight
Return Code | ID | Description |
|
|
|
NWSE_Success | 0 | Command successfully completed. |
NWSE_InvalidUsage | 1 | Invalid usage: bad parameter usage, conflicting |
|
| options specified. |
NWSE_RPCTimeout | 2 | Request was issued, but was not serviced by the |
|
| server. RPC procedure timed out and the request may |
|
| or may not have been serviced by the server. |
NWSE_RPCNotConnected | 3 | Unable to connect to the RPC server. |
NWSE_NoPermission | 6 | Not authorized to perform this operation. |
|
|
|
Appendix H Service Processor Commands 181
