
Step 5: Configure WLANs
Access Port Adoption
Use this list to adopt detected Access Ports and to assign them to a particular WLAN. The switch can adopt up to six Access Ports at a time, but the list of allowed
This adoption list identifies each Access Port by its Media Access Control (MAC) address. This address is the Access Port’s
1.To adopt an access port, click the Add button to add a new criteria line to the table.
2.Specify the following fields:
Field | Description |
Start MAC | This field contains the lowest value in a range of MAC addresses that |
| will use this particular adoption criteria. To specify a single MAC |
| address instead of a range, enter it in this field and leave the End |
| MAC field blank. |
End MAC | This field contains that highest number in a range of MAC addresses |
| that will use this particular adoption criteria. If this value is empty, the |
| Access Port adopted by this criteria must match the Start MAC field |
| exactly. |
WLAN | The next one to three columns have the same names as the WLANs |
columns | that are enabled in the upper portion of the screen. Click on the |
| checkbox for a specific WLAN to associate the Access Ports that |
| match the MAC address range with the checked WLANs. |
Note: The default setting for the switch has both the Start MAC and End MAC addresses set to “ANY”, and all enabled WLANs checked. This setting allows all the WLANs to adopt any Access Port that it detects, automatically.
3. Click the Apply button to save changes.
Step 5: Configure WLANs
The Network Configuration
Copyright © 2004 Symbol Technologies, Inc. All Rights Reserved | 30 |
WS 2000 Wireless Switch: 1.0 Date of last Revision: March 2004 |
|