
WLAN—Advanced Access Port Settings
The advanced Access Port settings are found at the bottom of the screen. For most installations, the default settings for the advanced settings are appropriate.
1.Select either Indoors or Outdoors from the Placement
2.Select a channel number from the Channel
3.Select a power level from the Power Level
4.Select both the Slowest Supported Rate and the Fastest Supported Rate from the respective
5.Check the Antenna Diversity checkbox to enable Antenna Diversity if the Access Port has an external antenna.
6.Check the Support Short Preamble checkbox to allow the Access Port to communicate with the MUs using a short
A preamble is the beginning part of a frame. The preamble comprises such elements as robust carrier sensing, collision detection, equalizer training, timing recovery, and gain adjustment. The administration can choose between a long or short preamble for data- frame transmission from the WLAN’s adopted access ports.
Use the long preamble setting (the default) for legacy wireless equipment that is not capable of dealing with short preambles. Use the short preamble setting where legacy equipment is not an issue and maximum throughput is desired, for example when streaming video or
7.Set the Request to Send Threshold (RTS Threshold) by specifying a number.
RTS is a transmitting station’s signal that requests a Clear To Send (CTS) response from a receiving station. This RTS/CTS procedure clears the air when many mobile units (MUs) are contending for transmission time. Modifying this value allows the administrator to control the number of data collisions and thereby enhance communication with nodes that are hard to find because of other active nodes in the transmission path.
In this field, the administrator can specify a Request To Send (RTS) threshold (in bytes) for use by the WLAN’s adopted access ports.
This setting initiates an RTS/CTS exchange for data frames that are larger than the threshold, and sends (without RTS/CTS) any data frames that are smaller than the threshold.
Consider the tradeoffs when setting an appropriate RTS threshold for the WLAN’s access ports. A lower RTS threshold causes more frequent RTS/CTS exchanges. This consumes more bandwidth because of the additional latency (RTS/CTS exchanges) before transmissions can commence. A disadvantage is the reduction in
A higher RTS threshold minimizes RTS/CTS exchanges, consuming less bandwidth for data transmissions. A disadvantage is less help to nodes that encounter interference and collisions. An advantage is faster
Copyright © 2004 Symbol Technologies, Inc. All Rights Reserved | 48 |
WS 2000 Wireless Switch: 1.0 Date of last Revision: March 2004 |
|