Troubleshooting 6

If the head convergence test pattern resembles the following example, select a number that is lower than the current setting to move the center line to the left. For example, if the current setting is +0, select –1. (Factory default is 0.)

--

+

8344RN-5

If the proper head convergence cannot be achieved by using the –4to +4 range, there may be a problem with the printer. Call your dealer or Tektronix service.

6.Press the TEST PRINT button several times to return to this message.

Utilities Vx.xx

Exit Next

7.Press the CLEAN PRINT HEAD button to exit the Utilities mode.

8.Make another test print to check the results.

User Manual

6-11

Page 120
Image 120
Tektronix Phaser 300X user manual 8344RN-5