Tektronix Phaser 300X user manual Rear panel switches, Switch Function Settings

Front and Rear Panels 7

Rear panel

Rear panel switches

Note Changes to rear panel Switches 5, 6, and 7 do not take effect until you reset the printer or turn it off and back on again. Changes to Switches 8 and 9 take effect immediately.

Rear panel switches

Switch	Function	Settings
1	Reset/run	Up: The printer resets and does not accept data while
		the switch is in this position.
		Down: The printer runs a self-test, then proceeds to run
		normally. Leave the switch down for normal operation.
2, 3, 4	Configuration	Up: When only Switch 4 is moved from down to up, the
	Page/	printer prints a configuration page. See the table
	Diagnostics	“Switches 2, 3, and 4: Diagnostics” on page 7-6.
5	Start Job	Up: The Sys/Start job on the hard disk does not run.
		Down: The Sys/Start job runs if the file exists on the disk.

6Set paper size Up: For metric-size media. Down: For American-size media.

7Baud Rate Up: Fixed. Sets the serial communication parameters to 1200 baud, software flagging, and ignore parity.

		Down: Variable. Lets you change the serial
		communication parameters. The factory setting is 9600
		baud, software flagging, and ignore parity.
		For information on how to change the serial port settings
		when Switch 7 is in the down position, refer to the
		Phaser 300X Drivers and Utilities Printing Reference for
		details on the setdevparams PostScript command.
8 and 9	Color	See the table “Switches 8 and 9: Color Correction Mode”
	Correction	on page 7-6.

User Manual 7-5