
www.ti.com
MDIO Registers
4.15 MDIO User PHY Select Register 1 (USERPHYSEL1)
The MDIO user PHY select register 1 (USERPHYSEL1) is shown in Figure 29 and described in Table 28.
Figure 29. MDIO User PHY Select Register 1 (USERPHYSEL1)
31  | 
  | 
  | 
  | 
  | 
  | 16  | 
  | 
  | Reserved  | 
  | 
  | 
  | |
  | 
  | 
  | 
  | 
  | 
  | |
15  | 8  | 7  | 6  | 5  | 4  | 0  | 
Reserved  | 
  | LINKSEL | LINKINTENB  | Reserved  | 
  | PHYADRMON | 
  | 
  | |||||
LEGEND: R/W = Read/Write; R = Read only; 
Table 28. MDIO User PHY Select Register 1 (USERPHYSEL1) Field Descriptions
Bit  | Field  | Value  | Description  | 
Reserved  | 0  | Reserved  | |
7  | LINKSEL | 
  | Link status determination select bit. Default value is 0 which implies that the link status is  | 
  | 
  | 
  | determined by the MDIO state machine. This is the only option supported on this device.  | 
6  | LINKINTENB  | 
  | Link change interrupt enable. Set to 1 to enable link change status interrupts for PHY address  | 
  | 
  | 
  | specified in PHYADRMON. Link change interrupts are disabled if this bit is set to 0.  | 
  | 
  | 0  | Link change interrupts are disabled  | 
  | 
  | 1  | Link change status interrupts for PHY address specified in PHYADDRMON bits are enabled  | 
5  | Reserved  | 0  | PHY address whose link status is to be monitored  | 
PHYADRMON | 
  | PHY address whose link status is to be monitored  | 
80  | Ethernet Media Access Controller (EMAC)/Management Data Input/Output (MDIO)  | SPRU975B   |