Bar Code Setup
On the Bar Code Setup screen key in the number that corresponds to the setup parameters you would like to change.
BAR CODE SETUP |
|
CODE 3 OF 9 | 1 |
2 | |
3 | |
CODE 128 | 4 |
2 OF 5 CODES | 5 |
CODABAR | 6 |
MSI/PLESSEY | 7 |
CODE 93/CODE 11 | 8 |
DATABAR/RSS/OTHERS | 9 |
DONE/EXIT | 0 |
PLEASE SELECT #: _ |
|
In each section you select the Default settings are shown in bold print, and the other options are shown in standard text. You can toggle between settings by keying in the corresponding number that for the parameter you want to change.
Code 3 of 9 (Code 39)
CODE 39 OPTIONS
CODE 39 | ON/OFF 1 |
FULL ASCII | ON/OFF 2 |
ACCUMULATE MODE | ON/OFF 3 |
TRANSMIT START STOP ON/OFF 4 | |
MOD 43 CHECK DIGIT | ON/OFF 5 |
TRANSMIT MOD 43 | ON/OFF 6 |
CAPS LOCK | ON/OFF 7 |
DECODE OPTION | 0/1/2 8 |
DONE/EXIT | 0 |
CHANGE SETTING #: _
oThe Start and Stop character for Code 39 is the * character. Setting 4 determines whether or not those characters are transmitted to the computer along with the data. For example, at setting ON, the data of 1234 would be transmitted as *1234*. Transmitting the start and stop characters can be useful if you need to differentiate between data that comes from a bar code versus data coming
from the keypad.
oEnabling use of the Mod 43 check character requires that the last character of your bar code conform to the Mod 43 check character specifications. See Appendix F: Code 39 for more information. Enable transmission (6) will send the check digit data
along with the rest of the bar code data to your computer. To use 6, you must also be using 5.
oCaps Lock ON causes lower case letters read as data to be transmitted to the computer as UPPER CASE, and upper case letters to be transmitted as LOWER CASE. Numbers, punctuation and control characters are not affected. Caps Lock OFF means that
letters will be transmitted exactly as read. This setting applies to all bar code types.
oSee Appendix F: Code 39 for more information regarding Accumulate Mode.
oDecode Option is used to allow reading of Code 39 bar codes through a windshield. Setting this option to 1 will loosen up the decoder a little and option 2 will loosen up the decoder a bit more. This should be used with caution since using a looser decoder can cause substitutions.
32
