Xantrex Technology XG 850 manual Clearing Alarms, Clearing Triggered and Manual Alarms

	Alarms and Errors
Clearing Alarms
Clearing Triggered and Manual Alarms
	To clear a triggered alarm, use one of the following methods:
	• Turn the power supply Off and then On.
	• Press and hold the rotary Adjust/Enter control for 3 seconds.
	• Press the reset key combination (Flash Fail ONLY). See “Resetting the
	Power Supply” on page 3–39.
	To clear a manual alarm:
	1. Press and hold the rotary Adjust/Enter control for 3 seconds.
	The ALr CLr message will be displayed on the front panel for a few	3
	seconds.
	Important: When an alarm is cleared by using this method, only the current
	highest precedence alarm is cleared. If another alarm has occurred, then this
	alarm will now become the highest precedence alarm and will begin blinking on
	the display.
	2. Repeat the alarm clearing until you have cleared all alarms.
Clearing a Flash Failure Alarm
	The Flash Failure alarm is the only exception for clearing alarms. Flash
	failure can only be cleared by a reset (see “Resetting the Power Supply”
	on page 3–39) or by power cycling the unit.
	To clear a triggered alarm, use one of the following methods:
	• Turn the power supply Off and then On.
	• Press and hold the rotary Adjust/Enter control for 3 seconds.
	• Press the reset key combination (Flash Fail ONLY). See “Resetting
	the Power Supply” on page 3–39.
	The SCPI command (s) for these instructions are:
	[:]OUTPut[<channel>]:PROTection:CLEar

M370078-01 3-19