Remote Operation
4.From the Hyper Terminal (or any other terminal program) select the Transfer>Send Text File…
5.Navigate to and select the text file that was previously stored. Click the Open button.
6.Execute the program recording stop command:
:PROG:STOP
7.Execute the readback command to verify the entire program was transferred correctly:
PROG:READ?
8.Set the data rate back to the original speed.
9.Close the connection to the HyperTerminal program and configure the connection data rate to be the original speed.
Running an Auto Sequence Program:
Once an auto sequence program has been stored, there are a few commands that can be used to run the program. Once a program begins running, it will continue running until completion and then repeat the number of times specified by the repeat command. The default at power on is to have repeat set to 1.
Commands:
*TRG
[:]INITiate[<channel>][:IMMediate] [:]PROGram[<channel>]:STATe {?RUNSTOPPAUSe}
Where:
RUN causes the program to begin execution. STOP causes the program to stop execution
PAUSe causes the program to stop executing at the current command. If a subsequent run is sent, the program will resume executing with the next command in the program.
For Example:
:PROG:STAR
*IDN?
*IDN?
:PROG:STOP
