Xerox 3300MFP manual Installing accessories, Precautions when installing accessories

15 Installing accessories

Your machine is a full-featured one that has been optimized to meet most of your printing needs. Recognizing that each user may have different requirements, however, Xerox makes several accessories available to enhance your machine’s capabilities.

This chapter includes:

•Precautions when installing accessories

•Installing a memory DIMM

Precautions when installing accessories

Disconnect the power cord

Never remove the control board cover while the power is being supplied.

To avoid the possibility of an electrical shock, always disconnect the power cord when installing or removing ANY internal or external accessories.

Discharge static electricity

The control board and internal accessories (network interface card or memory DIMM) are sensitive to static electricity. Before installing or removing an internal accessories, discharge static electricity from your body by touching something metal, such as the metal back plate on any device plugged into a grounded power source. If you walk round before finishing installation, discharge any static electricity once again.

Installing a memory DIMM

Your machine has a dual in-line memory module (DIMM) slot. Use this DIMM slot to install additional memory.

The Phaser 3300MFP has 96 MB of memory. It can be expanded to 320 MB. However, users must remove the preinstalled memory DIMM before upgrading the memory.

For order information for optional memory DIMMs, see page 12.1.

1Turn the machine off and unplug all cables from the machine.

2Grasp the control board cover and slide toward you to open it.

1

1 control board cover

3Completely open the latch on each side of the DIMM slot. Remove the preinstalled memory DIMM.

1

2

1 latch

2 memory DIMM

4Take out a new memory DIMM from the plastic bag.

5Holding the memory DIMM by the edges, align the notches on the memory DIMM with the grooves on the memory DIMM slot.

Note

The notches and grooves illustrated above may not match those on an actual DIMM and the slot.

15.1 <Installing accessories>