Yamaha AW2400 owner manual About the AUX buses, AUX Send Level Adjustment, 111

Chapter 13

AUX

This chapter describes operation of the AW2400 AUX buses.

About the AUX buses

The AW2400 has 4 auxiliary buses that can be assigned to the [OMNI OUT] jacks, the [DIGITAL STEREO OUT] connectors, or the outputs of an optional I/O card installed in the I/O slot. This can be useful for sending signals to external signal processing gear, or for monitoring specific signals within a mix.

Signals from the following channels can be sent to the AUX buses.

•Input channels

•Track channels

•Effect return channels

HINT

•Refer to “Output signal patching” on page 104 for details on assigning the AUX bus outputs.

•AUX 1/2 and 3/4 can be assigned as pairs (→ p. 58).

AUX Send Level Adjustment

AUX send levels can be adjusted either by using the graphic knobs in the AUX screen or by using the Selected Channel section controls.

13

AUX

■Adjusting AUX send levels via

the AUX screen

AUX send levels can be adjusted using the graphic knobs in the AUX screen.

1 Press the Selected Channel section [AUX] key so that its indicator lights.

The AUX screen will appear.

NOTE

•If the AUTO DISPLAY function is set to OFF, press one of the Selected Channel knobs (1–4) after pressing the [AUX] key so that its indicator lights. For details about the AUTO DIS- PLAY function refer to “AW2400 Preferences” on page 210.

2 To adjust levels for the AUX1 bus press Selected Channel knob 1.

The AUX1 screen will appear.

To adjust levels for the AUX2–AUX4 buses press the corresponding Selected Channel knob (2–4) in the same way. If the [AUX] key is lit pressing one of the Selected Channel knobs will take you directly to the corresponding AUX screen.

3 Press the Display section [F1] (Input/RTN page) or [F2] (Track page) key.

The page displays and the items they contain are as follows.

AW2400 Owner’s Manual

111