Yamaha AW2400 owner manual About the built-in CD-RW drive, Using the CD-RW drive, Handling

About the built-inCD-RW drive • Using the CD-RW drive

1

About the built-in CD-RW drive

Before you start

A built-in CD-RW drive is a device that lets you create or play audio CDs, backup and restore data from the internal hard disk, and read data from a CD-ROM.

IMPORTANT

•Even if a CD-RW drive is operating normally, it may fail a read or write operation approximately once in five hundred times.

•Yamaha will take no responsibility for any damages, direct or consequential, that may result from the use of the above CD- RW drive.

■Handling

1Never touch the objective lens.

BBe careful that the objective lens does not become dusty or dirty.

CIf the objective lens becomes dusty, use a commer- cially available blower etc. to blow the dust off with clean air.

DSince the inside of the drive contains powerful mag- netic circuitry, do not allow any magnetic material to come near the drive. (In particular, any metallic frag- ments, screws, or pins that enter the drive mechanism will cause operation to fail.)

Using the CD-RW drive

To insert a disc into the CD-RW drive, press the eject switch. The disc tray will open. Place the disc on the tray, and gently push the disc tray in.

NOTE

•The disc tray is ejected electrically. If the disc tray is not ejected when you press the eject switch, turn on the power of the AW2400 and press the eject switch once again.

Eject hole Eject switch

■Removing a CD in an emergency

If you are unable to remove the disc by pressing the eject switch, insert a wire of less than 2 mm diameter (such as a straightened paper clip) into the eject hole, and push gen- tly. However, pressing the eject switch will not eject the disc when the AW2400 is in the following states, so do not use this method in such cases.

•When the AW2400’s power is “OFF”

•When the disc is being accessed (data is being read, written, or erased)

•While in CD PLAY mode

CAUTION

•This removal method is for use in emergencies such as when you cannot remove the disc due to a malfunction of the disc tray or a power failure. Do not use this method unnecessarily, since doing so will damage the CD-RW drive.

12

AW2400 Owner’s Manual