Command Editing Automix data In a Speciﬁed Region

Automix Operation • Command Editing Automix data In a Specified Region

6 Move the cursor to the MODE ﬁeld and turn the REC button on.

The REC button will ﬂash. This engages the Automix record standby mode, and the [AUTOMIX] key will ﬂash red.

HINT

•The AUTOREC button can be turned on rather than the REC button to engage the Automix record standby mode.

7 Use the Layer section keys to select the mixing layer that includes the channels you want to operate.

8 Press the top-panel PLAY [ ] key to start song playback.

The [AUTOMIX] key will light red and Automix recording will begin. But at this point no channel has been selected so no data recording will actually take place.

9 When the punch-in point is reached use the [INPUT SEL], [SEL], or [STEREO SEL] keys to select the channel for which Automix data is to be recorded.

The selected key will ﬂash orange and the correspond- ing channel’s parameters can be recorded to Automix.

10 Operate the fader as required.

HINT

•If no operations are performed between the punch-in and punch-out points all data corresponding to the selected parameter data in the selected channel will be erased. This is a handy way to erase all occurrences of speciﬁed data in a speciﬁed punch-in/out region.

11 When the required operations have been performed press the same key that you pressed in step 9.

The key will go out and Automix recording will stop (punch out). The Automix record mode will remain active, but since no channel is selected no data can actually be recorded (you can press the key again to punch in again and continue recording if desired).

HINT

•After punching the fader move in and out, the fader will return to the previously-recorded level at a rate determined by the speciﬁed return time.

12 When all required mix operations have been recorded, press the top-panel STOP [■] key to stop the song.

A popup window asking you to conﬁrm whether you want to update the recorded Automix data will appear.

13 To conﬁrm and update the recorded data move the cursor to the OK button and press the [ENTER] key.

The recorded Automix data will be updated.