Yamaha AW2400 Internal effect inserted pre-EQ input channel, Signal flow is as follows, 120

Inserting an Effect Into a Channel

5 Use the [DATA/JOG] dial or [INC]/[DEC] keys to select the desired effect and/or I/O card channel, then press the [ENTER] key.

When EFF1–4 is selected the corresponding effect will be inserted in the signal path.

Insert points

The signal flow is as follows.

■Internal effect inserted pre-EQ (input channel)

6 To select the insert point move the cursor to the symbol below INSERT EFF on the display and press the [ENTER] key.

Press [ENTER] repeatedly to sequentially select the pre-EQ → post-EQ pre-fader → post-fader insert points.

When an effect and compressor are both inserted at the same point you can move the cursor directly to the insert point and press the [ENTER] key to swap the positions of the effect and compressor.

●INSERT EFF = EFF 1

Effect 1

PHASE GATE

ATT

EQ

ON LVL

7 Call the EFFECT screen FX Edit page or FX Lib. page to adjust the internal effect mix balance (the balance between the effect and direct signals).

■External effect inserted pre-EQ

(input channel)

When SLOT1–16 is selected an external effect processor

14 can be inserted into the channel via the selected I/O card channel. In this case the signal flow is as follows.

Effects	● INSERT EFF = SLOT1
		External effect
		processor
	Output channel = 1		Input channel = 1
		I/O card
	PHASE	GATE		EQ
			ATT	ON LVL

8 Use the MIX BALANCE field knob to bal- ance the effect and direct sound as required.

A setting of 0% produces only the direct sound while a setting of 100% produces only the effect sound.

HINT

•Refer to “Editing Effects” on page 121 for details on the EFFECT screen FX Edit page.

120

AW2400 Owner’s Manual