Yamaha AW2400 owner manual Selected Key Lit Knob, Dyn

Basic operation of the AW2400

2 Press the SELECTED CHANNEL section [DYN], [AUX], [EFFECT], or [PAN/EQ] key so that its indicator light, according to the parameters you want to control.

With the default settings the screen corresponding to the pressed key will

2 appear automatically. The display will not change if the UTILITY screen Preference page AUTO DISPLAY button is set to OFF (→ p. 211).

Introducing the AW2400

The parameters that can be controlled by the SELECTED CHANNEL knobs are as follows:

Selected Key (Lit)	Knob 1	Knob 2	Knob 3	Knob 4
	Multiple compressor parame-
[DYN]	ters, or the last parameter	Compressor threshold.	Compressor ratio.	Compressor gain.
	operated, depending on the
	control status.
[AUX]	Send level from channel to	Send level from channel to	Send level from channel to	Send level from channel to
	AUX 1.	AUX 2.	AUX 3.	AUX 4.
[EFFECT]	Send level from channel to	Send level from channel to	Send level from channel to	Send level from channel to
	EFFECT 1.	EFFECT 2.	EFFECT 3.	EFFECT 4.
[PAN/EQ]	Pan	Equalizer Q.	Equalizer frequency.	Equalizer gain.

HINT

•After selecting a channel, press the SELECTED CHANNEL [VIEW] key to call the CH VIEW screen where you can edit the channel signal routing and all of the channel parameters. Refer to page 105 for details on the CH VIEW screen.

NOTE

•The parameter controlled by SELECTED CHANNEL knob 1 when the [DYN] key is engaged depends on the current operating status (→ p. 153).

•If you operate SELECTED CHANNEL knob 1 immediately after recalling a setup from the compressor preset library, multiple compressor parameters will be adjusted simultaneously, changing the overall effect of the compressor (the type of change depends on the recalled preset library setup).

•When individual compressor parameters for a channel have been adjusted via the DYNAMICS screen, the last parameter adjusted is assigned to SELECTED CHANNEL knob 1 (the last-adjusted parameter is individually retained for each channel).

3 Rotate SELECTED CHANNEL knobs 1–4 to adjust the cor- responding parameters as required.

If the UTILITY screen Preference page AUTO DISPLAY button is set to OFF, a popup window showing the corresponding parameter name and the value will appear while the knob is being operated.

34

AW2400 Owner’s Manual