Yamaha AW2400 owner manual Select PRE for pre-fader or Post for post-fader send, 118

Applying Effects via Send and Return

6 Move the cursor to the PRE/POST button and press the [ENTER] key to switch the location from which the signal will be sent from each channel to the Effect buses.

Select PRE for pre-fader or POST for post-fader send.

7 To adjust the effect mix balance (the bal- ance between the effect and direct signals), press the [F3] key.

The EFFECT screen FX Edit page will appear.

8 Use MIX BALANCE field knob to adjust the balance between the direct and effect sig- nals.

When applying an effect via the effect sends and returns the effect mix level is usually set to 100% (effect sound only).

HINT

•The effect parameters can be edited as required via the FX Edit page. Refer to “Editing Effects” on page 121 for details.

9 The effect send master levels can be adjusted via faders 9–12 after pressing the Layer section [MASTER] key.

When the MASTER mixing layer is selected faders 9– 12 control the master send levels for effects 1–4, respectively. You can view and edit the various param- eters for each master send channel by pressing [SEL] key 9–12 and then calling the CH VIEW screen View page.

14

Effects

10 To adjust the effect return levels press the Layer section [IN 1-8] or [IN 9-16] key, and use faders 9–12 to adjust the correspond- ing return levels.

When mixing layer IN 1-8 or IN 9-16 is selected fad- ers 9–12 control the return levels for effects 1–4, respectively. You can view and edit the various param- eters for each return channel by pressing [SEL] key 9– 12 and then calling the CH VIEW screen View page.

HINT

•See “Displaying the mix parameters for individual channels” on page 105 for details.

118

AW2400 Owner’s Manual