Writing audio data

Writing Track At Once

Here’s how to use the Track At Once method to write ste- reo tracks from songs saved on the hard disk to CD-R/RW media. Use this method if you expect to be adding tracks to the disc later, or if you want an automatic two-second gap between tracks.

1 Make sure that the appropriate virtual track is selected for the stereo track of the song(s) you want to write.

Only the virtual track that can be played by the stereo track (i.e., the “current track”) will be written to disc. If the correct virtual track is not selected, load the desired song, use the TRACK screen Stereo TR page to switch to the correct virtual track, and then save the song.

2 Call the CD screen Write page by either pressing the Work Navigate section [CD] key as many times as necessary, or by pressing the [F1] key after pressing the [CD] key.

3 Insert a CD-R/RW disc in the drive, move the cursor to the TRACK AT ONCE button, and press the [ENTER] key.

The inserted CD-RW will be automatically checked.

HINT

If data has already been written on the inserted CD-RW disc, a popup window will appear immediately after step 3 asking whether you want to erase the data. If you want to erase the entire disc move the cursor to the OK button. If you want to cancel the audio CD write operation, move the cursor to the CANCEL button. Then press the [ENTER] key.

4 Move the cursor to the ADD button and press the [ENTER] key.

The track list will show information (track number/ song name/size of the stereo track) for the song that will be written to track 1 of the CD.

HINT

When you move the cursor to the ADD button and press the [ENTER] key, a new song will be added following the existing songs.

By using the INSERT button instead of the ADD button, you can insert a new song immediately before the song that is selected in the list.

You can use the DELETE button to delete the currently selected song from the track list.

5 Move the cursor to the dotted frame in the track list, and use the [DATA/JOG] dial or the [INC]/[DEC] keys to select the song that will be written to track 1.

or

HINT

Songs in which data has not been recorded on the virtual tracks selected for the stereo track will not be displayed. A current song that was not saved after the stereo track was recorded will also not be displayed.

Songs with a stereo track shorter than four seconds will not be displayed.

Songs with the sampling frequency of 48 kHz will not be dis- played.

6 Repeat steps 4 and 5 to select the songs that will be written to track 2 and following.

HINT

Pressing the [F1]–[F3] keys while holding the Display section [SHIFT] key has the same effect as the ADD ([F1] key), INSERT ([F2] key), and DELETE ([F3] key) buttons, respec- tively.

NOTE

CD

• When you add a song to the track list, the added song will

audioanCreating

always be initially selected. Change this as required.

 

22

AW2400 Owner’s Manual

217

Page 217
Image 217
Yamaha AW2400 owner manual Writing Track At Once, Inserted CD-RW will be automatically checked, 217