Yamaha AW2400 owner manual Midi Synchronization Message Setup, 198

Basic MIDI Settings • MIDI Synchronization Message Setup

FOTHER field

MIDI messages other than program change and control change messages are set up here.

•ECHO button (TX)........ Received MIDI messages other than program and control change are re-transmitted (“echoed”) via the MIDI OUT/ THRU connector (or USB con- nector or digital I/O card output port).

GREMOTE OUT box

Selects the connector/port via which MIDI messages will be transmitted when the MIDI Remote function is active (when the REMOTE screen is showing). Refer to

page 204 for details on the MIDI Remote function.

NOTE

•The same connector/port as selected in the PORT field or THRU box cannot be selected here.

HTHRU box

Specifies the connector/port for “THRU” output of MIDI messages received via the MIDI IN connector (or USB connector or digital I/O card input port). If “MIDI” and “USB 1” are selected for the two THRU boxes, THRU output will be as follows:

•Messages received at the MIDI IN connector will be THRU output via the USB output port 1.

•Messages received at the USB input port 1 will be THRU output via the MIDI OUT/THRU connector.

MIDI messages generated by the AW2400 itself are not transmitted via connectors/ports selected for THRU out- put.

NOTE

•The same connector/port cannot be specified for both boxes.

•The same connector/port as selected in the PORT field or REMOTE OUT box cannot be selected here.

MIDI Synchronization Message Setup

The MIDI screen Setting 2 page allows selection of MIDI messages used for synchronization with external equipment (MTC and MIDI clock) as well as messages used for remote control.

20

MIDI

To call this page press the Work Navigate section [MIDI] key as many times as necessary, or press the [F2] key after pressing the [MIDI] key.

C B A F G H I J

D E K

This page contains the following items.

1MMC field

Specifies how MMC will be transmitted/received.

BMMC OFF button

Engage this button (it will appear inverted) to disable MMC transmission and reception.

CMMC MASTER button

When this button is turned on the AW2400 functions as MMC master, and the appropriate MMC commands will be output via the MIDI OUT/THRU connector (or USB connector or digital I/O card output port) when the trans- port is operated. Turn this button on when you want to remotely control external equipment from the AW2400.

DMMC SLAVE button

When this button is turned on the AW2400 functions as MMC slave, and will respond to appropriate MMC com- mands received via the MIDI IN connector (or USB con- nector or digital I/O card input port). Turn this button on when you want to remotely control the AW2400 from external equipment.

198

AW2400 Owner’s Manual