Applying EQ To an Input Signal

Applying EQ To an Input Signal

The AW2400 provides versatile 4-band equalizers on every channel that can be directly operated via the Selected Channel section keys and knobs.

This section describes the procedure for applying EQ to input channels 1–8.

6

Track recording

1 Press the Layer section [IN 1-8] key so that its indicator lights, the press the [SEL] key for the channel to which EQ is to be applied.

HINT

The [INPUT SEL] 1–8 keys can also be used to select an input channel for equalization.

2 Press the Selected Channel section [PAN/ EQ] key so that its indicator lights. Press Selected Channel knob 1, 2, 3, or 4 and the PAN/EQ screen will appear.

3 Press the Display section [F3] key to call the EQ/Att. page.

The EQ settings are available via this page.

EQ ON/OFF button

4 To turn the EQ on, move the cursor to the EQ ON/OFF button and press the [ENTER] key.

5 Press the Selected Channel section [LOW], [LO-MID], [HI-MID] or [HIGH] key to select the EQ band to be adjusted.

6 Use Selected Channel section knobs 2–4 to adjust the EQ as required.

When the [PAN/EQ] key is lit, Selected Channel knobs 2–4 perform the following functions: knob 2 adjusts the Q, knob 3 adjusts the center frequency, and knob 4 adjusts the gain of the selected band.

7 Repeat steps 5 and 6 to set all bands as required.

HINT

In addition to the ability for fine EQ control as described above, the supplied EQ library contains preset EQ setups for a variety of instruments that can be recalled and used or edited as required. Refer to “Pan, EQ, and Dynamics Pro- cessing” on page 147 for details.

HINT

Pages can also be selected by repeatedly pressing Selected Channel section knobs 1–4.

60

AW2400 Owner’s Manual

Page 60
Image 60
Yamaha AW2400 owner manual Applying EQ To an Input Signal, EQ settings are available via this