Chapter 6 Tutorials

Figure 54 Network > Interface > Trunk > Edit > Member

4Use the default values for the rest of the settings. Click OK to save these changes and return to the previous screen.

6.1.4Zones

This example sets up the LAN, WAN, and DMZ zones as shown below.

Table 32

Zones Example

 

ETHERNET

DEFAULT ZONE

FINAL ZONE

INTERFACE

 

 

ge1

 

LAN

LAN

 

 

 

 

ge2

 

WAN

---

 

 

 

 

ge3

 

WAN

WAN

 

 

 

 

ge4

 

DMZ

WAN

 

 

 

 

ge5

 

DMZ

DMZ

 

 

 

 

Ethernet interface ge2 does not have any physical ports associated with it, so it does not matter to which zone it is assigned or if it is assigned to any zone at all. The only change you must make is to remove ge4 from the DMZ zone and add it to the WAN zone. The following steps accomplish this by removing ge4 from the DMZ zone and changing WAN member ge2 into ge4, leaving ge2 unassigned to any zone.

1Click Network > Zone. The following screen appears.

Figure 55 Network > Zone, Initial

2Click the Edit icon for DMZ, as shown above because you have to remove ge4 from the DMZ before you can add it to the WAN.

130

 

ZyWALL USG 1000 User’s Guide