Chapter 31 Content Filter Screens

31.1.3 Content Filter Configuration Guidelines

You must configure an address object, a schedule object and a filtering profile before you can set up a content filter policy. When the ZyWALL receives an HTTP request, the content filter searches for a policy that matches the source address and time (schedule). The content filter checks the policies in order (based on the policy numbers). When a matching policy is found, the content filter allows or blocks the request depending on the settings of the filtering profile specified by the policy. Some requests may not match any policy. The ZyWALL allows the request if the default policy is not set to block. The ZyWALL blocks the request if the default policy is set to block.

31.2 Content Filter General Screen

Click Anti-X > Content Filter > General to open the Content Filter General screen. Use this screen to enable content filtering, view and order your list of content filter policies, create a denial of access message or specify a redirect URL and check your external web filtering service registration status.

Figure 347 Anti-X > Content Filter > General

The following table describes the labels in this screen.

Table 146 Anti-X > Content Filter > General

LABEL

DESCRIPTION

General Setup

 

 

 

Enable Content Filter

Select this check box to enable the content filter.

 

 

Policies

This is a list of the configured content filter policies.

 

 

464

 

ZyWALL USG 1000 User’s Guide