Chapter 34 User/Group

The following table describes the labels in this screen.

Table 163 User/Group > Setting > Force User Authentication Policy > Add/Edit

LABEL

DESCRIPTION

Enable

Select this if you want this condition to be active.

 

 

Description

Enter a description for this condition. It can be up to 60 printable ASCII characters

 

long.

 

 

Authentication

Select whether users must log in (force) or whether users do not have to log in

 

(skip) when this condition is checked and satisfied.

 

 

Source Address

Select a source IP address object or select Create Object to configure a new one.

 

Select any if this condition applies to traffic from all source addresses.

 

 

Destination

Select the destination address of traffic to which this condition applies or select

Address

Create Object to configure a new one. Select any if this condition applies to traffic

 

from all destination addresses.

 

 

Schedule

Select the schedule object that specifies when this condition applies or select

 

Create Object to configure a new one (see Chapter 37 on page 527 for details).

 

Select none if this condition always applies.

OK

Select this to save your changes and return to the previous screen.

 

 

Cancel

Select this to return to the previous screen without saving any changes.

 

 

34.5 Web Configurator for Non-Admin Users

Access users cannot use the Web configurator to browse the configuration of the ZyWALL. Instead, when access users log in to the ZyWALL (forced in the screen as shown in Figure 375 on page 510 or otherwise), the following screen appears.

Figure 377 Web Configurator for Non-Admin Users

 

513

ZyWALL USG 1000 User’s Guide