ZyXEL Communications ZyWALL 1000 4.8 VPN Express Wizard - Remote Gateway, 4.7.1 VPN Express Wizard

Chapter 4 Wizard Setup

Click the Express radio button as shown in Figure 33 on page 96 to display the following screen.

Figure 34 VPN Express Wizard: Step 2

The following table describes the labels in this screen.

Table 15 VPN Express Wizard: Step 2

LABEL	DESCRIPTION
Name	Type the name used to identify this VPN connection (and VPN gateway). You may
	use 1-31 alphanumeric characters, underscores(_), or dashes (-), but the first
	character cannot be a number. This value is case-sensitive.
Secure	Enter the WAN IP address or domain name of the remote IPSec router (secure
Gateway	gateway) to identify the remote IPSec router by its IP address or a domain name. Set
	this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address.

Pre-Shared	Type your pre-shared key in this field. A pre-shared key identifies a communicating
Key	party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to
	share it with another party before you can communicate with them over a secure
	connection.
	Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-
	9", "A-F") characters. Precede hexadecimal characters with “0x”.
	Both ends of the VPN tunnel must use the same pre-shared key. You will receive a
	PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not
	used on both ends.

Next	Click Next to continue.

The Remote Gateway policy identifies the IPSec devices at either end of a VPN tunnel.